電蒸汽鍋爐廠家http://www.hw5668.cn/介紹排污是蒸汽鍋爐的重要環節，不過，在日常蒸汽鍋爐使用及監管檢驗中,我們對蒸汽鍋爐承壓部分、爐體部分都較重視, 存在的問題都能及時按要求給予解決處理,而對于鍋爐需要進行排污。

1、電蒸汽鍋爐廠家介紹先開一次閥，再緩慢開啟二次閥；排污前，保證是在高水位，低負荷的前提下進行排污。
Electric steam boiler manufacturers introduced the first open a valve, then slowly open the second valve; before discharge, to ensure that the sewage water level in the context of high and low loads.

2、電蒸汽鍋爐廠家介紹首先打開爐前排污閥，再緩慢打開爐后排污閥，此步驟切記要緩慢打開，目的在于一是暖管，二是防止突然開啟時，發生意外。
Electric steam boiler furnace manufacturers introduced first open the drain valve, then slowly open the drain valve after the furnace, this step remember to slowly open, one aimed at heating pipe, the second is to prevent a sudden turn when the accident occurred.

3、電蒸汽鍋爐廠家介紹暖管時要緩慢開爐后排污閥至全開，然后再關閉此閥，再次打開爐后排污閥，再關閉，反復此操作二至三次（一般是三次），開啟閥門時間控制在2-3秒，禁止兩臺鍋爐同時進行排污。
Electric heating tube steam boiler manufacturers introduced after furnace slowly drain valve to open, and then close the valve and open the drain valve after the oven again, then close and repeated this two or three times (usually three times), open the valve timing control in 2-3 seconds, two boilers at the same time prohibiting the sewage.

5、電蒸汽鍋爐廠家http://www.hw5668.cn/介紹在排污過程中，如鍋爐發生事故，應立即停止排污，但汽包水位過高和汽水共騰除外。
Electric steam boiler manufacturers introduced in the sewage process, such as boiler accident, should immediately stop the sewage, but drum level is too high and Priming excluded.